Compact 4 Channel
2.4 GHz Video & Stereo Audio Transmitter with SMA Antenna connector.
Fully self contained only
requires Power Supply & Antenna, 1.5 metre AV Cable included.
[REG12-1.3]
(1.3 x 3.8 Plug)
Plug Pack$12
[Cable-3813/L]
$3
(1.3
x 3.8 Plug on figure 8 cable) [Batt-11V]
Battery Pack- 22 Watt
Rechargeable
Pictured with
optional Ant-Stub Antenna, Ant-Whip or higher Gain recommended for best
results.
TX-Mini is a Wireless Audio &
Video Transmitter with a range in ideal clear line-of-sight conditions of up to
~ 100 metres with 3 dB & 5 dB Whip antennas, up to 1 ~ 2 kilometres with 24 dB
High Gain antennas.
Applications:
Business
Observe showrooms, warehouse, offices, doors, etc without the need to install
expensive and inflexible wiring
Distribute images to multiple remote Monitors (VCR) for training, presentation
or general surveillance and observation
View images from Satellite TV, Pay TV, Cable TV, DVDs, VCRs, Computers, Cameras,
Quads, Multiplexers, etc in multiple rooms from one source without distribution
amplifiers or wiring.
Transmit your message to multiple TVs / Monitors in showrooms, tradeshows, etc
without wires.
Entertainment
View & Listen all over the house and even out on the patio or pool area from a
central source
Enjoy Satellite TV, rented tapes and DVDs in every room of the house without
expensive wiring
Safety
See who is outside your door using a Video Camera and your regular TV.
Monitor your baby, your children, the swimming pool, the elderly, ill or
disabled using your camcorder or a CCTV Video Camera.
Observe your home or office on a monitor with up to four cameras.
Specifications:
TV System: Suits ALL TV Systems in ALL
Countries, operation is independent of TV System.
ISM Band: 2.4 ~ 2.483 GHz 4 Channels Audio & Video.
Modulation Method: FM.
Oscillator: P.L.L. (Phase Locked Loop).
Video Input: Standard 1 v p-p, 75 ohm Composite Video via 2.5 mm mini socket &
1.5 metre cable with RCA Plug.
Audio Input: Maximum 2 v p-p, via 2.5 mm mini socket & 1.5 metre cable with RCA
Plugs.
RF Output Power: 10 mW EIRP (maximum allowed) with 3 dBi Whip antenna, 50 ohms
impedance, SMA Female Socket.
Power Supply Requirements: 9 ~ 12 VDC, 1.3 mm x 3.8 mm socket,
center pin = (+)
.
Current: ~ 180 mA @ 10.5 Volts.
Dimensions: ~ 52 mm (W) 60 mm (H) 20 mm (D) excluding sockets & antenna ~ 40
grams.
Wireless Video & Audio RF
Transmission link for covert spy and Cable-Free Wireless CCTV Video Surveillance
Cameras, Quad Screen Processors, Switchers, Monitors, Multiplexers, Video
Recorders, Digital PC Recording.
Portable Wireless Video
Transmitter for covert pinhole video camera surveillance in Shops - Showrooms -
Exhibitions - Work Places - Casinos - Theatres - Concerts - Nightclubs - Outdoor
Events - Cinemas - etc. Portable Home Video Surveillance to monitor Swimming
Pools - Caravans - Boats - etc.
Observation of Horses - Show
Animals - Livestock - etc during transportation in Floats - Trucks - etc.
Automobile Rear Vision and
general observation Video Systems for Caravans - Large Boats - Semi Trailers -
Road Trains - Aircraft - Buses - Modern or Historic choo.. choo..
Trains - etc.
Wireless AV link for VCRs,
Satellite TV, DVD, PCs, Pay TV, MDS, Cable TV, Lightweight Compact Video Cameras
for shooting video program material, Remote Control: Cars - Boats - Hovercraft -
etc.
In Australia Video Transmitters
may be legally used without a licence within the *LIPD 2400 ~ 2483 MHz Band and
10 mW *EIRP limit.
RANGE
Depends on Surroundings,
Obstructions, other Transmitters (2.4 GHz Cordless Phones, Wireless LAN, etc),
Antenna Alignment, Electromagnetic & Radio Frequency interference in the
vicinity. This device may be affected by and may affect other devices that
operate on or near the same frequency causing minor to severe interference.
In ideal, clear, Line-of-Sight
conditions with Vertical 3 dBi Whip antenna on TX
Vertical 3 dBi Whip antenna on
Receiver up to ~ 100 metres.
Correctly matched and aligned 24
dBi antenna on Receiver up to ~ 1000 metres.
Correctly matched and aligned 24
dBi antenna on Transmitter (see note below) & Receiver up to ~ 2000 metres.
Due to the nature of Radio Signals
results are unpredictable (in the same manner as Mobile / Cellular Telephones)
signals reflected from surrounding objects arriving at Receiver antenna may
Add-to or Subtract-from the direct signal from Transmitter. Directional antennas
may reduce affect of reflected signals.
Range and Signal to Noise Ratio
(SNR) may be improved by increasing gain of antenna on Receiver and/or
Transmitter (in Australia TX may only be fitted with 3 dBi antenna). For
maximum signal transfer TX and RX antennas should be the same polarity, that is
both oriented Vertically or Horizontally.
High Gain Vertical Whip Antenna 2.4 ~
2.5 GHz, ~ 12 dBi gain, ~ 50 ohms impedance. Antenna for Wireless LAN,
WiFi Network, Wireless ADSL, Video Transmitters, etc.
Length: ~ 1210 mm, ~ 1425 mm with
Base Mount Tube. Diameter: ~ 42 mm @ Base ~ 22 mm main center section
~ 24 mm top cap. Weight: ~ 670 grams ~ 930 grams with Mounting Tube &
Clamp/Bracket.
Supplied with Base Mount Tube and
Clamps/Brackets for surface or Tubular Mast mounting.
High Gain Vertical Whip Antenna 2.4 ~
2.5 GHz, ~ 15 dBi gain, ~ 50 ohm impedance. Beamwidth: Horizontal
360º, Vertical 11º. VSWR (Voltage Standing Wave Ratio) ~ 1.5. Maximum
Power 50 Watts. Antenna for Wireless LAN, WiFi Network, Wireless ADSL,
Video Transmitters, etc.
Length: ~ 1640 mm, ~
1935 mm with Base Mount Tube. Diameter: ~ 42 mm @ Base ~ 20 mm main
center section ~ 22 mm top cap. Weight: ~ 680 grams ~ 950 grams with
Mounting Tube & Clamp/Bracket.
data sheet
Yagi Antenna 2.4 ~ 2.5
GHz, ~ 17.5 dBi gain, ~ 50 ohms impedance. Beamwidth: E23, H24.
Antenna for Wireless LAN, WiFi Network, Wireless ADSL, Video
Transmitters, etc.
Dimensions (excluding
Clamps) ~ 850 mm, ~ 75 mm diameter, ~ 800 grams, ~ 500 mm RG-58 Coax
cable. Supplied with Aluminium mounting plate, Clamps, etc. Pictured
in Vertical Polarity orientation * Mast not included.
Grid-Parabolic Antenna
for Wireless LAN, WiFi Network, Wireless ADSL, Video Transmitters,
etc. 2.4 ~ 2.5 GHz, ~ 24 dBi gain, ~ 50 ohm impedance. Beamwidth: ~
11º (H) ~ 7º (V). Front:Back ~ 25dB. VSWR ~ 1.5. Maximum Power 100
Watts.
Supplied with Clamps to
suit 40 ~ 50 mm Tubular Mast, bracket for Vertical or Horizontal
mounting 60º Tilt in 10º increments. Aluminium Grid (2 sections) ~
1060 (W) ~ 600 (H) mm assembled. Weight ~ 2.8 kg including mounting
bracket.
Pictured in Horizontal
Polarity orientation.
data sheet
SMA male (internal thread, pin contact, Hex Nut) to N female.
Suitable for P18G & P24G discontinued antennas.
Cat Code: SMAm-Nm
$10
SMA male (internal thread, pin
contact, Hex Nut) to N male. Suitable for W12dB, W15dB, F16, F18,
F20 & P24 antennas.
Cat Code: SMAm-m
$10
SMA male (internal thread,
pin contact, Hex Nut) to SMA male. Suitable for P10 antenna.
Cat Code:
Cable-178/30 $19
30 cm RG-178 Coax cable
with SMA male & female connectors.
Cat Code:
Cable-58/450 $39
~ 450 cm Coax Cable with SMA male & female connectors. Attenuation
0.6 ~ 0.9 dB/metre @ 2 GHz., 0.8 ~ 1.4 dB/metre @
5.8 GHz
Cat Code:
Cable-23/450N $39
not pictured ~ 450 cm Coax Cable with SMA & N male
connectors. Attenuation ~ 0.75 dB/metre @ 2.4 GHz, ~
0.8~1.4 dB/metre @ 5.8 GHz. Suitable for W12dB, W15dB,
F16, F18, F20 & P24 antennas.
Parabolic, Yagi & Flat
are directional antennas. Whip antennas when used vertically are
for most practical purposes omni or non directional.
To maximise 'Range'
minimise the length of Coax Cable between Antenna and TX/RX.
Antenna Gain... what does
it mean ??? a simplified explanation
Received signal strength
from an antenna with 3 dBi gain will be double that from an antenna that has
0 dBi gain, received signal strength from a 6 dBi will be double that from a
3 dBi and so on... An increase in antenna gain of 3 dBi is approximately
equal to doubling the transmitter output, received signal strength or range
can be increased by raising antenna gain or transmitter output. Range can be
doubled by either increasing antenna gain by 6 dBi or quadrupling the
transmitter output.
The maximum allowed 2.4 GHz
LIPD Video Transmitter output power is 10 milliwatts (mW) EIRP (in
Australia), increasing transmitter output is illegal and therefore not an
option.
Increasing the gain of the
receiver antenna is an alternative to increasing transmitter output. In very simple terms: increasing antenna gain from 0 dBi to 3
dBi is equivalent to raising the output power of a 10 mW transmitter to ~ 20
mW. (5 dBi to ~ 33 mW) ( 8 dBi to ~ 66 mW) (12 dBi to ~ 160 mW) (15 dBi to ~
320 mW) (18 dBi to ~ 640 mW)
* LIPD = Low Interference
Potential Devices. * EIRP = Equivalent Isotropically Radiated Power.
Source: Australian Communications Authority
Click below for information on Frequencies & Power Limits
http://www.aca.gov.au/legal/licence/class/lipd.htm
** Information
plagiarised from this page may be found on 'copy-cat' Web Sites **
Use your Browser "Back Button"
to return to previous page
Video Transmitter & Audio 2.4
GHz AV Sender with SMA Antenna connection for High Gain Antennas suitable for
transmission of signals from Wireless Covert Tiny Hidden Pinhole Spy Video
Cameras, DVR, VCR, Satellite TV, DVD, PC, Pay TV, Surveillance Cameras, Cable
TV, Remote Control Cars - Boats - Hovercraft, Security Cameras, Portable &
Covert CCTV Video Surveillance * Range up to 100 metres - up to 1.2 kilometres
with High 18 dB Gain Antennas.
